Early Vision Trainer
Improving visual perception in babies & in young children with special needs.
Includes console, kit and guidelines.
|
EARLY VISION TRAINER ASSEMBLY |
Console, middle shelf and top shelf (with side tabs) |
Open the Console half-way, lie it flat on the floor, use the Velcro tile to secure the middle split. |
|
Lift the Console up to full height & keep it steady. |
Fit middle shelf: first hold it vertical & push the ends into the two side holes.... |
...then swivel it down until slotted - use one hand round the back for a tight fit. |
|
Fit top shelf: this time middle tab first, then each side tab. With thumb & fingers pull each top hole over the end pipe (it's a bit stiff first time) |
Make sure the tabs on both shelves are snug and a good tight fit as in the picture. |
The trainer is best sited in a corner but try other places for the most natural light.
|
|
...be sure to use the cord at the back & tie it to a fixed point for safety. |
If baby is lying or supported on the floor, use the bottom half of the console & clip reflective materials etc. on the middle shelf. |
If baby sits on your knee or a wheelchair is used, clip your dangly stuff (or materials in the kit) from the top shelf and use the mid-shelf for rolling. |
